[TUTO] How to install and configure picons on OpenATV

Here is an image tutorial that shows you how to install and configure picons on Vu + decoders under a OpenATV image.

N.B: This tutorial is valid for all versions of Black Hole and VU + models (SOLO, SOLO2, UNO, ULTIMO, DUO, DUO2, SOLO SE, ZERO, ZERO 4K, SOLO 4K, UNO 4K,UNO 4K SE, DUO 4K, ULTIMO 4k,).

For this tutorial you need.

Material:

A Vu+ decoder (SOLO, SOLO2, UNO, ULTIMO, DUO, DUO2, SOLO SE, ZERO, ZERO 4K, SOLO 4K, UNO 4K,UNO 4K SE, DUO 4K, ULTIMO 4k,).

 

Winscp for WINDOWS

 

PICONS 220 × 132 for satellite

– Launch WINSCP in the home window

File protocol: FTP

Hot name: 192.168.1.100 (ip address of your DREAMBOX )

User name: root

Password: “empty” by default the root password in OpenATV is empty (no password needed)

After clicking on Login

Unpack the Picon ASTRA 220 × 132 file

Select the picon folder and drag between the two windows to the /usr/share/enigma2 folder.

MENU – Setup

Usage and GUI

Channel selection Settings

Enable Show picons in channel list

press GREEN button to save

Then restart your receiver

Congratulation you have Picon now on your OpenPLi SKIN 🙂

*******************************************************************

You can install the picons on the internal flash memory of your receiver, the internal hard disk, a USB key

Command to add when copying picon to the internal hard drive

ln -s /usr/share/enigma2/picon /hdd/picon

Command to add when copying picon to USB stick

ln -s /usr/share/enigma2/picon/usb/picon